Telos Alliance xNode2 Broadcast Audio Interfaces
Tataiso ea ho Qala ka Potlako
Telos Alliance xNode2 IP Audio Interface
Unboxing le Setupo
Upon opening the package, you will find the following components:
- xNode2 Unit
- Rack Mounting Brackets
- Motlakase oa Motlakase
- Lithapo tsa Marang-rang
- Lisebelisoa tse ling
Mehato ea ho Kenya
- Connect the xNode2 to a power source and network switch. Allow approximately 40 seconds for the device to boot up.
- Tobetsa konopo ea matla hang ho kenya sesebelisoa.
- Hold the button for 5 seconds to reset the network settings if necessary.
- Configure the network settings on the display screen:
- Network Port 1 (top): Enter IP address, subnet mask, and AoIP settings.
- Network Port 2 (bottom): Enter IP address, subnet mask, and AoIP settings.
- Access the xNode2 interface by entering the IP address into a web browser on a connected computer.
- Log in using your username and password.
Lisebelisoa tse Eketsehileng
For further information and detailed documentation, visit: docs.telosalliance.com/xnode2
Litlhaloso
| Karolo | Tlhaloso |
|---|---|
| xNode2 Unit | IP Audio Interface Device |
| Networks Ports | Two network ports for connection |
| Phepelo ea motlakase | Standard power cable included |
LBH
- How do I reset the network settings?
- Hold the power button for 5 seconds to reset the network settings.
- Where can I find the IP address for the xNode2?
- The IP address is displayed on the device screen after setup.
- Ke lokela ho etsa'ng haeba ke sa khone ho kena ho web segokanyimmediamentsi sa sebolokigolo?
- Ensure the device is properly connected to the network and that the correct IP address is entered in the browser.
Litokomane / Lisebelisoa
 |
Telos Alliance xNode2 Broadcast Audio Interfaces [pdf] Bukana ea Mosebelisi xNode2, xNode2 Broadcast Audio Interfaces, Broadcast Audio Interfaces, Audio Interfaces |
