FCOB WS2812B SPI RGB IC LED Strip with Remote Controller User Manual

3.2ft-DC5V2A 10W; 6.4ft-DC5V4A 20W; 9.8ft-DC5V6A 30W;
13.1ft-DC5V8A 40W; 16.4ft-DC5V10A 50W
The power of the light strip is not fixed. It will vary with the lighting effect and the length of the LED strip.

Waterproof Level: IP30 Non-waterproof

3PIN Connecting:

+V: +5V~~Red Wire DAT: Data~~Green Wire GND: -V~~White Wire
DI: Data Input
DO: Data Output

Mehato ya tlhokomelo

Verify the power supply output voltage matches the LED strip’s operating voltage (DC5V only). Use of DC12V/DC24V will cause irreparable damage and void warranty.

Actual power consumption varies with strip length. Extended lengths may induce voltaglerotholi.
Li-LED tse qetellong ea distal li ka bonts'a khanya e fokotsehileng ka lebaka la khanyetso ea tlhaho le voltage drop—an unavoidable physical characteristic common to all LED strips.

Lintlha tse Amang Khanya:

Bolelele: Moqtagho theoha ho ka etsahala ka bolelele bo atolositsoeng.
Tlhokahalo ea Matla: Etsa bonnete ba hore motlakase o na le wattagtekanyo ea e e kopana kapa e feta kakaretso ea tšebeliso ea matla a lesela la LED.
Mokhoa oa Lebone: Full-white mode (RGB mixed white) consumes signiﬁcantly more power than single-color modes.

Boemo ba ho Khanya: Higher brightness settings increase power consumption.

Tharollo:

MoqtagE Matšeliso: Inject additional power every 5 meters (16.4 ft).
Fokotsa ho Khanya: Lower brightness to decrease power demand.
Adequate Power Supply: Use a power source with sufficient wattage.

Avoid Full-White Mode: Minimize RGB-mixed white to reduce energy usage.
Sheba Manual: Latela "Series Connection & Voltage Supplementation” tataiso bakeng sa ho seta hantle.

Mehato e Meng: Litokiso tse ling li ka 'na tsa hlokoa ho latela maemo a ho kenya.

Recommend Controllers (Controller Sold Separately)

Tsebiso ea Tšebelisano ea Taolo

Tlhokahalo ea Bokhoni ba Bolaoli:

The controller must support an equal or greater number of IC chips than the LED strip. Insufficient controller capacity will result in partial illumination.

Hlokomela: Netefatsa palo ea IC chip ho li-strip tsa LED le molaoli pele u reka.

Power Supply Speciﬁcation:
Use only a DC5V high-current power supply to prevent:

Tšitiso ea lets'oao
Ts'ebetso e sa tsitsang
Ho hoama ho tsamaiso

(Controllers sold separately.

Phepelo ea Matla e khothalelitsoeng
(Power Supply Sold Separately)

Tlhahiso ea matla a DC5V10A
Tlhahiso ea matla a DC5V20A

Tataiso ea Lintlha:
The black arrow on the FPCB indicates the data ﬂow direction. Connect wiring strictly according to the arrow direction to ensure proper illumination.

Tlhahiso ea motlakase voltage matches strip speciﬁcations
Tlhokomeliso: Phatlalatso e fosahetsengtage ka etsa hore hlobolisa ho khathala.

Series Connection & Moqtage Tlatsetso

Parallel Connection & Voltage Tlatsetso

Hlokomela: The LED strip is constructed with 50cm (1.6ft) FPCB segments, resulting in solder joints at 50cm intervals.

DIY Connectors (Sold Separately) Installation Note:

Tataiso ea Lintlha:

Netefatsa tepo e nepahetseng ea tataiso ea ho kenya data nakong ea khokahanyo ho thibela ho se sebetse hantle.
10mm FCOB WS2812B IC RGB LED strip (160LED/m or 180LED/m density)

Strip to Strip

Wires to Strip

L Shaped Left Connectors

L Shaped Right Connectors

Aluminium ea LED

U shaped
V sebopeho

Lisebelisoa tsa LED

Ho kenya likoto
Theipi e khomarelang
3PIN JST Connector
Katoloso Cable

Lintlha tsa Tlhophiso

Do not bend, fold or crease the LED strip/tape in a horizontal direction.
Ka kopo ebola theipi ka bonolo, ho seng joalo e ka taboha ka lebaka la ho otlolla ho feta tekano.

Ka kopo, nka mehato e nepahetseng ea anti-static, tobetsa boto ea PCB ka bonolo, eseng bokaholimo ba LEDS, ho seng joalo e ka baka ts'ebetso ea lik'hemik'hale ha nako e ntse e tsamaea.
Do not over bend the LED strip to make the circuit break even the strip works ﬁne after over-bending the hot and cold contrast may cause PCB board disfunction either Bending radius>30mm(1.2in)

Tlhokomelo Bakeng sa Tšebeliso
Li-strips tsa LED ha li felise mocheso hantle ha li phuthoa. Sena se ka baka tšenyo ho Letlapa la LED.

Litharollo tsa Mabone a Setsebi:
Sehlopha sa rona sa boenjiniere se fana ka lits'ebeletso tsa meralo e ikhethileng bakeng sa lits'ebetso tsa hau tsa strip tsa LED. Ikopanye le rona bakeng sa moralo oa projeke ea litsebi mabapi le:

Mabone a litepisi
Khabiso ea khabinete ea veine
Ho kopanya leseli la siling
Mekhoa ea mabone a litsela
Mabone a khabiso ea khabinete

Our lighting specialists will deliver optimized solutions tailored to your speciﬁc requirements.

TLHOKOMELISO EC

Lebitso la khoebo: XDH Tech
Aterese ea khoebo: 2 Rue Coysevox Bureau 3, Lyon, 69001, France

Lengolo-tsoibila: axdh.tech@outlook.com

UK REP

Lebitso la khoebo: GSG CONSULTING GROUP LIMITED
Aterese ea khoebo: Montague houses unit 3 Matthew street, Manchester, M12 5bb, United Kingdom
Lengolo-tsoibila: GSG–GROUP@outlook.com
Litšebeletso tsa bareki lefatšeng ka bophara: support@fcob.com
Tšebeletso ea bareki ba US Amazon: fcobstrip@outlook.com

Tiisetso

Likhoeli tse 12

UL Certiﬁcation Notice
This LED strip is UL Listed (United States), certifying full compliance with ANSI/UL safety standards for electrical and ﬁre safety.

LBH

What happens if I use the incorrect power supply voltage?

Using an incorrect power supply voltage can cause irreparable damage to the LED strip and void the warranty.

How do I prevent voltage drop with extended strip lengths?

Ho thibela voltage drop, inject additional power every 5 meters (16.4 ft) along the strip length.

Litokomane / Lisebelisoa

FCOB WS2812B SPI RGB IC LED Strip with Remote Controller [pdf] Bukana ea Mosebelisi
WS2812B SPI RGB IC LED Strip with Remote Controller, WS2812B SPI RGB IC, LED Strip with Remote Controller, LED Strip with Remote Controller, LED Strip with Remote, Strip with Remote Controller, Remote Controller

Litšupiso

Bukana ea Mosebelisi

FCOB WS2812B SPI RGB IC LED Strip with Remote Controller

Lihlahisoa tsa lihlahisoa