devolo 8254 Multi Node Ethernet LAN Installation Guide

1. Rera marang-rang a hau
   • Power supply considerations: Each power rail needs a circuit breaker. You can use one breaker for both the charging station and MultiNode, or separate breakers. Multi Node is powered by L1/N, e.g., from the charging infrastructures’ mains circuit.
   • Sebaka: Large networks may need repeaters. Best range is up to 50 m per hop. 50–100 m may work, but over 100 m is not recommended.
   • Lipotoloho: One three-phase circuit for all devices gives the best results. Multiple circuits cause signal loss and noise. This can be solved with repeaters or by splitting networks via Ethernet.
   • Topology: The network self-organizes into a tree: master node is at the root, with regular nodes automatically acting as repeaters when needed.
   • Master node placement: Place it where Ethernet is easy to reach and signal paths are short. It is strongly recommended not to place it in the distribution unit.
   • Load management in EV charging scenarios: Since regular nodes connect only to the master, EV charging scenarios need careful upfront planning. For guidance, see user manual on the sehlahisoa websebaka.
2. Ho kenya motlakase
   •  DIN-rail mounting and proper wiring must be carried out by a qualified electrician, in compliance with standards.
   • Connect the Multi Node devices to the mains.
   • It is recommended to record each device’s serial number, MAC address, and installation location (e.g., parking spot, floor number) to support maintenance.
      You can provision the devices either before or after electrical installation, depending on what works best for your workflow.
3. Connect your laptop
   • Connect your laptop to the device you want to use as the master node, e.g., device next to the Internet gateway, with an Ethernet cable. By default, all Multi Node LAN 4TE devices start as regular nodes.
4. Bula the web segokahanyi
   • Bula a web sebatli le ho kenya: http://devolo-xxxxx.local.
   • Replace xxxxx with the last 5 digits of the device’s serial number.
5. Run the setup wizard
   
   Ha u bula web interface of a factory-default device, it automatically redirects you to the setup wizard.
   • Click the button “Create a new network”. This sets the connected device as the master.
     
   • On the above screen, wait for all nodes to join the network, then click “Continue”. On the next screen shown below, enter the settings and click “Save and apply to all nodes in the network”:
   • Powerline domain name: Choose a clear name for the Multi Node network to help identify it.
   • Powerline password: Protects the powerline domain.
   • Peo: A number from 0 to 59 that uniquely identifies a PLC network. It is recommended to leave this on automatic.
   • Lebitso la password: Protects the Multi Node network management channel.
   • Web password ea interface: Protects access to the web segokahanyi.
   • After the configuration is applied to all nodes, you will be automatically redirected to the Overview, which lists all nodes in your Multi Node network as shown below. It is recommended to provide meaningful names to nodes, e.g., include a reference to physical installation location.
     

Tšehetso

For questions or feedback, please contact us at support@devolo.de.

© 2026 devolo solutions GmbH