Selelekela
This manual provides instructions for the Generic Infrared Remote Control, Model Easytry18899. This remote is designed as a replacement for specific Alpine CDE series car stereo receivers. Please read this manual thoroughly before use to ensure proper operation and longevity of your device.
Ho lumellana
This remote control is compatible with the following Alpine CDE series car stereo receiver systems:
- Alpine CDE-104BTI
- Alpine CDE-102E
- Alpine CDE-103EBT
- Alpine CDE-103BT
- Alpine CDE-133BT
- Alpine CDE-135BT
- Alpine CDE-135EBT
- Alpine CDE-136BT
Bohlokoa: Ensure your original remote control or car stereo model number matches one of the listed compatible models. If your model is not listed, this remote may not be compatible.
Tlhophiso
This remote control requires no programming or code setup. Simply install the batteries, and it will be ready for use with compatible Alpine CDE series car stereo receivers.
Ho kenya Battery
- Sheba sebaka sa betri ka morao ho remote control.
- Theolela sekoahelo sa karolo ea betri tlase kapa ka lehlakoreng le bontšitsoeng ke motsu ho se bula.
- Insert two (2) AAA batteries, ensuring the positive (+) and negative (-) terminals align correctly with the markings inside the compartment.
- Replace the battery compartment cover by sliding it back into position until it clicks securely.
Image: Back of the remote control with the battery compartment open, illustrating the correct orientation for inserting two AAA batteries.
Setšoantšo: Pele view of the remote control, displaying its ergonomic design and button layout.
Litaelo tsa Ts'ebetso
The remote control operates using infrared (IR) technology. Point the remote directly at the IR receiver on your Alpine car stereo system for optimal performance. The maximum effective range is approximately 8 meters (26 feet).
Mesebetsi ea Motheo
Refer to your Alpine car stereo's original user manual for specific functions of each button, as this remote is a replacement and its buttons correspond to the original remote's layout and functions.
- Konopo ea Matla: Turns the stereo system on or off.
- Phahamiso ea Phahamiso / Tlase: E fetola molumo oa molumo.
- Track/Tune: Skips tracks or tunes radio frequencies.
- Source/Mode: Switches between audio sources (e.g., CD, Radio, Bluetooth).
- Khutsa: Silences the audio output.
- Other buttons will perform functions as labeled and as supported by your specific Alpine CDE model.
Tlhokomelo
- Ho hloekisa: Hlakola remote ka lesela le bonolo, le omeletseng. U se ke ua sebelisa lintho tse hloekisang metsi kapa lisebelisoa tse senyang.
- Phetoho ea Betri: Replace batteries when the remote's range decreases or it becomes unresponsive. Always replace both batteries at the same time with new AAA batteries.
- Polokelo: Boloka remote sebakeng se phodileng, se omileng hole le letsatsi le mocheso o feteletseng.
- Qoba ho Lahla: Sireletsa remote khahlanong le tšusumetso ea 'mele, kaha marotholi a ka senya likarolo tse ka hare.
Ho batle phoso
| Bothata | Lebaka le ka khonehang | Tharollo |
|---|---|---|
| Remout not arabela | Dead or incorrectly installed batteries. Obstruction between remote and stereo. Remote out of range. | Replace batteries with new AAA batteries, ensuring correct polarity. Remove any obstructions. Move closer to the stereo (within 8 meters). |
| Intermittent response | Weak batteries. IR sensor on stereo is dirty or obstructed. | Replace batteries. Clean the IR sensor on your car stereo. Ensure a clear line of sight. |
| Some buttons not working | Remote not fully compatible with specific stereo function. | Verify your stereo model is listed in the compatibility section. Refer to your stereo's original manual for supported remote functions. |
Litlhaloso
- Mohlala: Easytry18899
- Lebitso: Kakaretso
- Theknoloji ea Khokahano: Infrared (IR)
- Mofuta oa taolo: Taolo ea Likonopo
- Mmala: Ntsho
- Boholo ba Range: Limithara tse 8 (hoo e ka bang maoto a 26)
- Mohloli oa Matla: 2 x AAA Batteries (ha e kenyelelitsoe)
- Lisebelisoa tse Tšehetsoeng: 1 (one Alpine CDE series car stereo receiver)
- Sebopeho se Ikhethileng: Ergonomic design, direct replacement functionality.
Boitsebiso ba Warranty
Sehlahisoa sena se tla le a Guarantee ea matsatsi a 90 from the date of purchase. This warranty covers manufacturing defects under normal use. It does not cover damage resulting from misuse, accident, modification, or unauthorized repair. Please retain your proof of purchase for warranty claims.
Tšehetso
For any questions or issues not covered in this manual, please contact the seller or manufacturer directly. Refer to your purchase documentation for contact details.